thin film stress
Thin Film Stress is the mechanical stress stored in deposited films due to lattice mismatch, thermal expansion differences, or growth kinetics — causing wafer bow, film cracking, delamination, and transistor performance changes in semiconductor fabrication.
Sources of Film Stress
Intrinsic Stress (Growth-Induced):
- Arises from film microstructure during deposition.
- Columnar grain growth creates tensile stress (grains pull together).
- High adatom mobility (high T or low rate) → compressive stress.
- CVD, PVD, ALD films all have characteristic intrinsic stresses.
Thermal Stress (Mismatch-Induced):
- $\sigma_{thermal} = E \cdot (\alpha_{film} - \alpha_{substrate}) \cdot \Delta T$
- Where $E$ = Young's modulus, $\alpha$ = thermal expansion coefficient.
- SiN: $\alpha = 2.8$ ppm/°C vs. Si: $\alpha = 2.6$ ppm/°C — small mismatch.
- SiO2: $\alpha = 0.5$ ppm/°C — large mismatch, compressive at room temperature.
Stress Values for Common Films
| Film | Typical Stress |
|---|---|
| Thermal SiO2 | -300 MPa (compressive) |
| LPCVD Si3N4 | +1000 MPa (tensile) |
| PECVD SiN | +100 to -500 MPa (tunable) |
| PVD TiN | +500 MPa (tensile) |
| Thermal Silicon | -50 to +50 MPa |
Effects on Wafer and Devices
- Wafer Bow: Film stress causes curvature → affects litho overlay, CMP uniformity.
- Film Cracking: Excessive tensile stress in thick films → network cracks.
- Delamination: Excessive compressive stress → film buckles and peels.
- Stress Engineering: Intentional stress improves carrier mobility — tensile SiN over NMOS boosts electron mobility ~10–20%.
Measurement Methods
- Wafer bow gauge: Capacitive or optical — before/after film deposition.
- Stoney's Equation: $\sigma = \frac{E_{sub} t_{sub}^2}{6(1-\nu_{sub}) t_{film}} \cdot \kappa$
- XRD: Lattice parameter shift maps absolute biaxial stress.
Thin film stress management is a critical process integration challenge — balancing deposition conditions to achieve target stress while preventing wafer distortion or film failure throughout the fabrication flow.