static noise analysis
Static Noise Analysis (SNA) is the technique for verifying that noise on internal chip signals does not cause functional failures — analyzing whether signal disturbances from coupling crosstalk, power supply noise, and leakage currents can generate glitches that propagate through combinational logic to reach and corrupt flip-flop inputs, potentially causing the chip to produce wrong results.
Noise Sources on Chip
| Source | Mechanism | Magnitude |
|---|---|---|
| Capacitive crosstalk | Adjacent wire switching couples noise | 50-200 mV |
| Power supply noise | IR drop and L di/dt | 30-100 mV |
| Leakage current | Off-state transistors inject current on quiet wire | 10-50 mV |
| Charge sharing | Parasitic capacitance redistribution | 20-100 mV |
| Miller coupling | Gate-drain capacitance of driving transistor | 20-80 mV |
How Noise Causes Failures
1. Aggressor wire switches → coupled noise appears on victim wire.
2. Noise pulse enters combinational logic gates.
3. Each gate either attenuates the noise (below switching threshold) or propagates it.
4. If noise reaches a flip-flop setup/hold window → wrong value captured → functional failure.
Static Noise Analysis Flow
1. Extract parasitics: Coupling capacitances between all wire pairs.
2. Compute noise: For each net, calculate worst-case noise from all aggressors.
3. Propagate through logic: Model each gate's noise rejection/propagation.
4. Check at flip-flops: Compare noise amplitude at FF input to noise margin.
5. Report violations: Nets where noise exceeds margin → potential functional failure.
Noise Metrics
- DC Noise Margin (NM): $NM_H = V_{OH} - V_{IH}$, $NM_L = V_{IL} - V_{OL}$.
- Dynamic noise immunity: How wide a pulse a gate can absorb without propagating.
- Noise bump: Maximum voltage disturbance at each net due to coupling.
- Propagated noise: Noise amplitude after passing through logic gates.
Timing vs. Noise
- SI-aware STA: Crosstalk DELAYS timing (speeds up or slows down transition) → checked in STA.
- SNA: Crosstalk creates GLITCHES on quiet nets → checked in noise analysis.
- Both analyses needed: Same physical coupling causes both effects.
Noise Prevention
- Wire spacing: Increase space between sensitive nets and aggressors.
- Shielding: Route ground wires between critical signal pairs.
- Net ordering: Route same-direction (same timing) nets adjacent — reduce relative switching.
- Buffer insertion: Buffers on long nets reduce noise accumulation.
- NDR (Non-Default Rules): Critical nets routed with wider spacing.
Static noise analysis is an essential signoff check for high-reliability chips — a noise-induced glitch that causes a single bit flip in a processor can corrupt data, crash a system, or cause a safety-critical failure, making systematic noise verification as important as timing verification for chip correctness.